MPS Racing: Holley Terminated Harnesses 10% Off

Print Friendly, PDF & Email

MPS Racing

Holley Terminated Harnesses 10% Off

The MPS Terminated Holley EFI Harness (p/n 1-0782) simplifies the installation of your Holley EFI on a Suzuki Hayabusa or similar (GSXR1000, ZX14, ZX10) motorcycle. The harness is heat shrink covered and terminates all the connections of critical components of the EFI system. Using this terminated harness will greatly reduce the chance of problems when installing your Holley EFI system.

If you are not comfortable or do not have the tools to crimp all the styles of connectors this harness is for you. It will plug into your injectors (customer specified type), igniter (MPS p/n 1-0783), coils (stock or aftermarket stick type), air temperature sensor (MPS p/n 1-0727), coolant temperature sensor (MPS p/n 1-0708), O2 Sensor (Bosch or NTK), 3 bar MAP sensor (MPS p/n 1-0764), fuel pressure (MPS p/n 1-0597), and oil pressure (MPS p/n 1-0598).

A MAP sensor is not required for normally aspirated or nitrous applications. Both fuel pressure and oil pressure are optional sensors. The throttle position sensor (TPS) is a direct plug in with a Gen 1, Gen 2 Hayabusa, and GSXR 1000. Be sure to specify. The ZX14 and ZX14 will need to use the connector from the stock harness.

We recommend using a hall effect cam sensor (MPS p/n 1-0649) on the Gen 1 Hayabusa. The harness will plug directly into this cam sensor and the factory Gen 2 cam sensor. For the stock crank sensor, you will need to cut the stock connector off and terminate the sensor wires with the male pin 3 conductor connector to match the MPS Holley EFI harness.


You must order by 7/31/2018 at 11:59 PM and mention DRAGBIKE.COM to get the special!


Motorcycle Performance Specialties
380 Orange Lane – Casselberry, Florida 32707
Phone: (321) 972-8282 – Fax: (321) 972-5123
Sales E-Mail: